View Full Version: Disable Seatbelt Warning Chime

www >>Sport Trac General >>Disable Seatbelt Warning Chime


<< Prev | Next >>

mooshin- 12-06-2009
Disable Seatbelt Warning Chime
Can anyone tell me the process for disabling the seat belt warning chime? There should be a process/key sequence to disable it.

ncranchero- 12-07-2009

SECTION 413-01: Instrumentation, Message Center, and Warning Chimes 2008 Explorer/Mountaineer/Explorer Sport Trac Workshop Manual
GENERAL PROCEDURES Procedure revision date: 07/17/2009

--------------------------------------------------------------------------------

Belt-Minder® Deactivating/Activating Printable View (79 KB)
Preparation

NOTE: The Belt-Minder® Deactivating/Activating procedure can also be carried out using the scan tool.

Apply the parking brake before deactivating/activating the Belt-Minder®.
Place the gear selector lever in PARK (P).
Place the ignition switch in the OFF position.
Close all the vehicle doors.
Unbuckle the driver and the front passenger safety belts.
Deactivating/Activating

Turn the ignition switch to the ON position (do not start the engine).
Wait until the safety belt warning indicator turns off (approximately 1 minute).
NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.

For the seating position being disabled, at a moderate speed, buckle then unbuckle the safety belt 9 times, ending with the safety belt in the unbuckled state. After this step the safety belt warning indicator illuminates for 3 seconds.
Within 5 seconds after the safety belt warning indicator turns off, at a moderate speed, buckle then unbuckle the safety belt.
This disables the Belt-Minder® feature for that seating position, if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
This enables the Belt-Minder® feature for that seating position, if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds followed by a second flash sequence after a brief pause.
After confirmation, the deactivation/activation procedure is complete.

mooshin- 12-07-2009

THANK YOU . THAN YOU!

JoeCool- 12-07-2009

Put on seatbelt?


Sorry, had be a smart-a... LOL

mooshin- 12-07-2009

I like to take it off when I'm sitting in the parking lot while waiting for my wife to get off work. Since it's getting cooler here I have the heat on at night. Just sick of the damn chiming.

JoeCool- 12-07-2009

Oh, yeah that is a pain. Used to get annoyed with the seatbelt chimes while working on Fords too. Sitting idle in park the stupid thing shouldn't go off. Also if you put something in the passenger seat, like a large dog.

mooshin- 12-22-2009

No more chimes. Took me a couple tries to get the disable sequence right.

Forumer™ is Voted #1 Free Forum Hosting provider
Build your own community today with the largest message board hosting company.

Terms of Use